Springtime Mosaic Stepping Stone Free Project Guide

Features

  • Free Mosaic Project Guide
  • Family pastimes can be a whole lot of fun when you work together to create this springtime stepping stone. Nestled in between the spring flowers will enhance any garden scene.
Find a Store
Project Tips
One 5 oz bag of stained glass chips is approximately 50 pieces. This will cover a 6” x 6” area with a 1/8” grout line.
 
If choosing to grout without gloves, use a vinegar wash to restore the PH to your hands to prevent your skin from drying out.
 
Materials
1each - 5 oz. packages Jennifer’s Mosaics™ Stained Glass Chips: pink, white, light blue, green, light green
Jennifer’s Mosaics™ Outdoor Cement
8” Round Stepping Stone Mold
Jennifer’s Mosaics™ White Grout
 
Tools
E6000® Glue or Clear Silicone
Jennifer’s Mosaics™ Wheeled Glass Nippers
 
Basic Supplies
Mixing Bowl and Spoon, Paper Towels and Newspaper, Sponge or Scrubby, Carbon Paper & Pencil
 
 
Instructions
1. To protect work area, cover with newspaper.
2. Mix the Outdoor Cement following the directions on the label. Wear a dust mask while mixing.
3. Pour cement slowly and evenly into mold; gently tap sides of mold to release any air bubbles in cement.
4. Do not move mold while the cement is drying. Wait approximately 24 hours (time may vary due to climate) for cement to harden. The cement will warm as it hardens.
5. Once it has cooled and set, remove the stone by turning mold over and lifting up the edges of the mold. (MOSAIC SHORTCUT: Use a premade stepping stone from you local hardware or garden center)
6. Determine the center of the stepping stone by using a ruler and a pencil. Find the center of the stone. Align the center of the pattern with the center of your stone. Place carbon paper between the pattern and the stone, tape to hold in place. Trace the pattern onto the stepping stone and remove pattern and carbon paper.
7. Use the picture as a guide and nip and arrange glass on the entire surface of the stone, leaving approximately 1/8” gap between pieces and at the outer edge. Nip glass pieces with a Wheeled Glass Nipper to fit inside pattern outline. (For nipping instructions, watch a video in our Creative Corner at www.DiamondTechCrafts.com)
8. Once you have achieved your desired look, lift each piece and apply a thin layer of glue to the back. Firmly press pieces onto the stone. Allow glue to dry according to the manufacturer’s instructions.
9. To grout the stepping stone, measure 1 cup of grout into a plastic bowl, reserve a few tablespoons of grout and set aside. Adding 1 tablespoon of water at a time to remaining grout, mix with craft stick until the grout reaches “fudge-like” consistency. If it is too watery, add the reserved dry grout in small amounts until the consistency is correct.
10. Wearing a disposable glove spread the grout onto the surface of the stepping stone and into all the spaces between the glass and tile. Wait about 15 minutes for grout to set.
11. Gently wipe away the excess grout using a paper towel taking care not to pull grout out of tile spaces. It is very important to remove any grout from the tile surface before grout is completely dry.
12.Use a soft cloth to buff the tiles to a clean shine.
13. Allow 24 hours for the mosaic piece to dry.

Sign up for projects